Seta Water Washout Tester – 19610-4
The Seta Water Washout Tester is used to evaluate the resistance of a lubricating grease from a bearing to washout by water.
Methods: ASTM D1264, IP 215, DIN 51 807, ISO 11009
Features
- New case design with large access panels for test hub and pump
- Recirculating bypass valve for pre-heating.
- Rapid warm up time
- Fully removable pump for servicing
- Integral bath drain
- Separate electronics compartment
- Easy to calibrate
The test bearing is mounted on a hub and rotated by an electric motor and toothed belt at 600 rev/min. A peristaltic pump draws heated water from the tank, through a filter, and sprays it, via a 1 mm capillary, onto the face of the bearing at a flow rate of 300 ml/min. The temperature of the water is digitally controlled in the range of ambient to 80 °C. The water containing washed out grease is collected in the tank, filtered and recycled. A drain tap allows the tank to be emptied at the end of a test.
The front panel has controls for water temperature, fine adjustment of water flow rate and bearing rotational speed, and a jet bypass switch to allow pre-heated water to circulate without passing through the jet.
Supplied with:
A test bearing for laboratory commissioning
5/32 inch and 2.5 mm Allen key screwdrivers
Instruction manual
| BEARING ROTATIONAL SPEED | 600 ±30 rev/min |
|---|---|
| TANK CAPACITY | 750 ml |
| TEMPERATURE RANGE | Ambient to 80 °C |
| WATER FLOW RATE | 5 ml/sec |
| VOLTAGE | 110/120 V, 50/60 Hz 220/240 V, 50/60 Hz (switchable) |
| POWER | 600 W |
| SIZE (HXWXD) | 30 x 40 x 40 cm |
| WEIGHT | 24 kg |
| CCCN CODE | Tariff 90318080 |
